If you finding honeywell thermostats for better life

Honeywell thermostats must meet the static and dynamic load conditions, depending on the use of the premises. The location and the evenness of the surface of the carrier deck must conform to tolerances irregularities requirements DIN18202 "tolerances in construction.

http://www.tms-nc.com/review-of-the-honeywell-th8320u1008-programmable-thermostat.htm
honeywell thx9321r5000
honeywell th8110u1003
honeywell th8110u1003 thermostats
    According to these requirements depending on the distance between the points of measurement acceptable tolerances surface roughness. Admission roughness of the area occupied by one coil should not exceed ± 5 mm. If you violate this requirement may be a problem not only with the launch of the site SOPs, but his subsequent work.
    The PEX pipes and wiring, which are placed on the supporting floor, must be secured. Then, using the leveling layer should create a flat surface so to be able to stowage insulating layer over the entire area. To do so, to schedule the desired structural height. To equalize the level of the floor should not be used bulk materials (such as construction waste or sand). If the heating  must carry prominent deviations (> 1.5%), for example, in the soul, then these deviations should make the floor in the carrier to comply with the requirement of uniform thickness reviving flooring. At the same time laying the Honeywell thermostat should be done in such a way as to preclude  .
    Clearances shifts in the carrier floor (building clearances) should have the same along the entire width, have delineated edges and run a straight line.
    Honeywell thermostat to the deck floor heating system must be dry.
    Seals against condensate and groundwater (waterproofing) shall be designed as an architect in accordance with DIN18195 and installed before the flooring floor heating system. When using PEX tubing bitumen waterproofing should be under the insulation plate made of rigid polystyrene foam polymers (PS) lay separating layer (for example, cardboard, plastic film) to reduce the softening effect on these plates.